Request a Quote
Menu ☰

Urban furniture · Practical application guide

Concrete urban furniture. Color & surface trials.

Select the matrix color for benches and planters, then measure its behavior after polishing, sealing and realistic maintenance.

Illustrative pigment application: Urban furniture.
Illustrative application image. Confirm the finished shade with physical samples.

Specify the concrete finish before selecting pigment

For a bench, planter or decorative post, mark the surfaces people will see and touch. Decide whether the finish is smooth cast, polished, etched or exposed aggregate. Pigment mainly colors the cement matrix; exposing different quantities of stone changes the apparent shade. Marshalls’ street-furniture guidance distinguishes these finish types and their maintenance considerations. Concrete furniture finish reference

Keep structural, fixing and impact requirements with the furniture designer. A colored bollard-shaped item is not automatically a vehicle-restraint product.

Make a white-cement sample ladder when a pale shade is needed

Aalborg White’s surface guide gives product-context examples of 1–2 kg pigment per 100 kg white cement for light coloring, and 3–5 kg for medium coloring. These are reference figures for its white-cement context, not a guarantee for every color or FUXIN grade. White-cement pigmentation guidance

For a supplier-approved initial comparison using 5 kg white cement per sample, the following low-to-medium ladder is easy to weigh:

SamplePigment / white cementDry pigment
Control0%0 g
A1%50 g
B2%100 g
C3%150 g

Use the furniture producer’s established aggregate, water and admixture quantities. This is not a concrete mix-design recipe. If the system uses gray cement or other binders, make a new series rather than assuming the white-cement shade will carry over.

Scale supply using the actual cement quantity

Suppose the accepted production recipe uses 2% on cement, and the documented yield assigns 2 kg cement to each of 50 identical pieces. Theoretical pigment demand is 50 × 2 × 0.02 = 2 kg, before measured manufacturing losses. This is a material-accounting example; the actual mix and yield determine the quantities.

Keep pigment batching tied to the mixer’s cement mass, not to an estimated scoop per item. If several furniture shapes have different volumes or mixes, calculate them separately. A plant should record losses and retained material rather than quietly increasing pigment percentage to make up a stock discrepancy.

Make a multi-face prototype

  1. Weigh and record each ingredient, then disperse pigment through the approved mixing sequence. Inspect for dots before casting.
  2. Use the intended mould and release system. Include a horizontal top, vertical face and curved edge so finish differences can be seen.
  3. Follow normal compaction, curing and demoulding. Apply the complete polishing or texturing route to the sample.
  4. Treat a marked area with the proposed sealer or anti-graffiti system while preserving an untreated reference. Compare dry shade, gloss and touch.
  5. Test the owner’s proposed cleaning method on the sample after the required cure. Record the cleaner, contact time and tool rather than merely reporting “cleaned.”

Approve maintenance as part of appearance

A clean untreated sample and a protected sample can differ visibly. Check the target in outdoor light and under the intended artificial lighting. Evaluate expected soiling with the treatment supplier’s test method; do not assume all pigment-containing furniture tolerates the same cleaner.

ProblemFirst comparison
Polished face differs from cast faceAggregate exposure and gloss
Dark patches around mould edgesRelease and finishing history
Cleaning leaves pale areasSurface etching or treatment damage
Protective treatment changes colorTreated versus untreated reference
Later pieces differCement, pigment and batch records

NPCA identifies raw materials and surface treatment as important color variables in precast products. Precast appearance context Complete the furniture’s required mechanical and exposure checks independently. Keep a finished control piece for repairs and new orders. Send FUXIN the cement type, selected sample, surface finish and treatment details when requesting a matching pigment grade and production quantity.

Technical references

Independent technical guidance used for this application overview. These references are not FUXIN project case studies or a substitute for a grade-specific technical data sheet.

Sample inquiry