Request a Quote
Menu ☰

Roads and municipal · Practical application guide

Municipal surfaces. Color system guide.

Distinguish cement-based, asphalt and resin-bound color systems before comparing dosage, material quantities or performance.

Illustrative pigment application: Roads and municipal.
Illustrative application image. Confirm the finished shade with physical samples.

Write the material route on the color brief

A municipal plaza, cycle route and traffic island can use concrete, asphalt or a bonded surface treatment. The same color name does not imply the same recipe. Record the binder system, exposure, texture, maintenance plan and whether color has a traffic-control or accessibility function. The responsible authority must define functional colors and road requirements; pigment selection does not replace that design.

Select the route before asking for a FUXIN sample. Cement-compatible powder, heat-stable asphalt pigment and an approved resin colorant are not interchangeable purchases.

Compare percentages with their actual reference masses

MAPEI’s Color Paving Pigment provides a useful contrast: its gray-cement recommendation is 3–6% on cement, whereas its asphalt recommendation is 3–6% on mix mass. These are its product-specific figures. Different dosage bases

At a hypothetical selected 4%:

Material referenceReference quantityCalculated pigment
Cement in a concrete sample10 kg cement0.4 kg
Final asphalt sample, using a final-total convention100 kg total mix4.0 kg
Bituminous binder aloneNot the stated asphalt basisDo not calculate from this alone

For the asphalt example, the remaining 96 kg is apportioned by the approved complete mix design; this is not permission to remove an arbitrary amount of aggregate or binder. Confirm whether the supplier’s percentage uses final total or an uncolored starting mix before issuing a batching instruction.

Recognize an aggregate-based asphalt specification

Another manufacturer can define a different basis. HA Italia’s 2024 catalog lists its synthetic red-oxide powder at 4–6% of aggregate mass. That is not the same percentage convention as total asphalt mix. HA.OXIDRED PW dosage table

For a selected 4% aggregate-based example, 1,000 kg aggregate requires 40 kg pigment, with binder and other components remaining part of the engineer’s approved formulation. Do not compare that 40 kg with a cement-based dose as though one product were necessarily more efficient. Compare completed sample area, appearance, required performance and the full material cost instead.

Make a decision-ready sample set

  1. Obtain samples of the shortlisted systems with their actual binder, aggregate and texture. Ask each producer to state its pigment reference mass and whether the shade comes from body color or a surface treatment.
  2. Label every sample with composition identifiers and finish. Compare dry and wet appearance beside neighboring materials.
  3. Reproduce the preferred system in an authorized trial area using its specified preparation, mixing and installation process. Document batch junctions.
  4. Make a repair sample with the intended maintenance material. An attractive new surface may still be difficult to patch convincingly.
  5. Collect the specified friction, wear, bond or other relevant performance results before the project team authorizes general use.

Keep color and high-friction claims separate

FHWA describes high-friction surfacing as an engineered combination of suitable durable aggregate and binder. A red or green surface does not automatically provide that function. Pavement friction guidance

DecisionEvidence to retain
Appearance approvalPhysical dry/wet sample and viewing conditions
Colorant quantityDeclared denominator and actual batch calculation
Traffic suitabilityRequired finished-system test reports
MaintenanceCleaning and repair trial
Functional colorProject authority’s accepted specification

If the target shade cannot be reached, review binder and aggregate color before increasing pigment. If a resin coating changes traction or drainage, review the whole treatment. Do not cover an unsatisfactory sample with a new unapproved sealer. Send FUXIN the selected material route and documented trial target so the inquiry concerns a specific pigment application rather than an undefined “road color.”

Technical references

Independent technical guidance used for this application overview. These references are not FUXIN project case studies or a substitute for a grade-specific technical data sheet.

Sample inquiry